coolant pump
英 [ˈkuːlənt pʌmp]
美 [ˈkuːlənt pʌmp]
冷却泵
双语例句
- Advantages& Disadvantages and Selection of Cooling Bed in Steel-pipe Product Line coolant pump motor
钢管生产线上各种冷床的利弊与选用冷却泵电动机-机床 - Steve Bowen and Alvin Drew spent six-and-a-half hours outside the orbiting platform, preparing it for the installation of a new store room and moving a faulty coolant pump.
斯蒂夫-波恩和阿尔韦恩-朱在轨道运行平台以外花了6个半小时进行维修；安装一个新储存室，取走一台有故障的冷却液泵。 - Improvement and practice of speed measurement system for reactor coolant pump
反应堆冷却剂泵转速测量系统改进设计及实践 - Fractional horsepower motor for minimachine tool coolant pump motor
小型机床用分马力电机冷却泵电动机-机床 - In a few rare cases there may be smouldering of the auxiliary coolant pump.
在少数情况下可能有闷烧的辅助冷却泵。 - Undo fastening screws of the coolant pump.
松开冷却液泵紧固螺钉。 - Study on the Seal Property of the Second Seals of Reactor Coolant Pump in Nuclear Station from Contacting to Non-contacting Mechanical Seal
流体静压式核电站主泵二级密封由接触式到非接触式转变的密封性能分析 - Study of Unsteady Flow and Fatigue Reliability of the Reactor Coolant Pump's Impeller
核主泵叶轮非定常流场及疲劳寿命可靠性分析 - The auxiliary coolant pump may fail at high operating temperatures.
辅助冷却泵可能会失败，在高工作温度。 - The test and analysis about the vibration damping and noise reduction of the canned coolant pump are studied.
对核动力装置屏蔽式冷却剂泵的减振降噪进行了测试与分析。 - Loosen the coolant pump pulley bolts while the belt is still tight.
在皮带仍然紧时，放松冷却水泵滑轮螺栓。 - Numerical simulation and analysis of three-dimensional flow in a primary coolant pump
主冷却剂泵三维流场数值模拟与分析 - Research on Longitudinal Seam Leaser Welder for Reactor Coolant Pump Can
核主泵屏蔽套激光纵缝焊接机的研制 - Analysis on Pressure Fluctuations of Unsteady Flow Field in Mixed-Flow Main Coolant Pump
混流式核主泵非定常流场的压力脉动特性分析 - Coolant pump motor closed circuit cooler for electric machine
冷却泵电动机-机床电机用闭式循环冷却器 - Possessing high technology reactor coolant pump is the pride of a nuclear power plant.
拥有技术上先进的反应堆冷却剂泵，是核电厂的骄傲。 - Study on Multiphase Flow and Fluid-Solid Coupling Vibration Characteristics of Reactor Coolant Pump
反应堆冷却剂泵多相流及流固耦合振动特性研究 - Disconnect cable plug of the additional coolant pump.
断开附加冷却液泵的电缆插头。 - The method for analysing the dynamic process of auxiliary bus voltage, frequency and coastdown of reactor coolant pump at the time of power supply failure was suggested.
通过秦山核电厂在电源事故情况下，厂用母线电压、频率的动态过程研究和主泵惰走的分析研究，阐述了这一问题分析研究的方法，给出计算结果并通过动态模拟试验进行验证。 - The Effect of Inertia Force in Water Lubricated Thrust Bearings of Canned Reactor Coolant Pump
屏蔽式主泵水润滑推力滑动轴承中惯性力的影响 - Experimental stress analysis for reactor coolant pump case of PWR NPP
压水堆核电站主冷却剂泵泵壳的实验应力分析 - The reactor coolant pump in nuclear power plant is the only revolving equipment in the nuclear power plant. Its functional stability will directly affect the security of nuclear power plant.
核电站反应堆冷却剂泵（又称核主泵）是核岛中的唯一旋转核心设备，其运行的可靠性与否直接影响到核电站的安全性。 - The running inertia of the main coolant pump is the key problem of the primary phase.
主循环泵转动惯量的取值是停堆初期冷却阶段的关键问题。 - A method of fault diagnosis for coolant pump system in nuclear heating pile is presented. It is the application of neuron network in the diagnosis of coolant pump system.
介绍一种诊断核供热堆冷却系统故障的方法，即神经元网络在冷却泵系统故障诊断中的应用。 - Commissioning of the Reactor Coolant Pump
反应堆主冷却泵的冷态调试 - Upper radial bearing, as the key component of the canned reactor coolant pump, has an important influence on the safe operation of the reactor coolant pump.
上径向轴承作为屏蔽电机主泵中的关键部件，其性能对核主泵的安全运行有着重要影响。 - Its advantages is little wear, low leakage and long life and so on, thus this seal is applied to some important occasions which require high pressure, high speed, such as coolant pump shaft seal of nuclear power station.
它具有磨损小、泄漏低和寿命长等优点，因此这种密封被应用于一些要求高压、高转速的重要场合，例如核电站主泵轴密封。 - Upper radial bearing which is a water-lubricated tilting-pad journal bearing, is installed in the reactor coolant pump motor, and always runs in high-pressure environments with the temperature of the lubricant under 80 ℃.
上径向轴承结构为水润滑可倾瓦径向轴承，安装在主泵电机内，长期处于高压环境中运行，且运行过程中要求润滑液温度不超过80℃。